Caterpillar D4K2 LGP bulldozer

ENGINE - Blow by: Minimal to none
ENGINE - Knocking: No knocking
ENGINE - Air cleaners: Good
ENGINE - Any smoke: Minimal to none
ENGINE - Oil or fuel leaks: None visible
ENGINE - General running condition: Runs well
TRANSMISSION - Gear change: HST works well
TRANSMISSION - Steering: Responsive
TRANSMISSION - Oil leaks: None visible
TRANSMISSION - Is the transmission noisy?: No
TRANSMISSION - Torque converter: No Noises
TRANSMISSION - Controls: Good controls
TRANSMISSION - General running condition: Moves well
UNDERCARRIAGE - Shoe height: 40mm, 75%
UNDERCARRIAGE - Shoes - any wear in trailing edge: Slight wear
UNDERCARRIAGE - Rail height: New
UNDERCARRIAGE - Any signs of link failure: No
UNDERCARRIAGE - Average diameter of pins and bushings: New
UNDERCARRIAGE - Have pins been turned on chains: New
UNDERCARRIAGE - Sprockets: New
IDLERS - UNDERCARRIAGE - Left side front idler: New
IDLERS - UNDERCARRIAGE - Right side front idler: New
TOP ROLLERS - UNDERCARRIAGE - Left side roller: New
TOP ROLLERS - UNDERCARRIAGE - Right side roller: New
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 1: 155mm x 155mm, 70%
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 2: 156mm x 155mm, 70%
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 3: 156mm x 155mm, 70%
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 4: 155mm x 156mm, 70%
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 5: 156mm x 156mm, 70%
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 6: 156mm x 156mm, 70%
BOTTOM ROLLERS - UNDERCARRIAGE - Roller 7: 156mm x 157mm, 70%
CAB - Cab mounts - any wear: Good mounts
CAB - Any wiring for laser system: Yes
CAB - Back up alarm: Loud and clear
CAB - Battery isolator switch: Manual fitted
CAB - Lights: All working
CAB - Wipers: All wipers and washers work
CAB - Heater: Good heat
CAB - A/C: Good cold A/C
CAB - Seat condition: Works as should, good condition
CAB - Cladding condition: Good condition
CAB - Floor mat condition: No wear or tears
CAB - Seat belt: Working
CAB - Mirrors: Rear view only
CAB - Horn: Loud and clear
CAB - Cab mounts: Good mounts
CAB - Cab glass condition: Good condition
CAB - Cab glass have any cracks?: No damage
BLADE - Blade width: 3100mm
BLADE - Blade height: 930mm
BLADE - Main Lift Rams, wear: L/H: 1mm x 1mm, R/H: 1mm x 1mm
BLADE - Pitch ram, wear: L/H: 2mm x 3mm, R/H: 3mm x 2mm
BLADE - Tilt ram, wear: 2mm x 2mm
BLADE - Ball joint, wear: 3 - 4mm
BLADE - C-Frame, wear: 3mm x 2mm
BLADE - Cutting edges condition: 25mm left
BLADE - Have cutting edges been turned?: No
BLADE - General blade condition: Good condition
PAINT & DECALS - Any damage to panels: No damage
PAINT & DECALS - Paint condition: Fair
PAINT & DECALS - Any areas repainted: No
PAINT & DECALS - Any rust patches: Minimal
PAT blade
Rippers available at an additional cost